Step 1. Create a section where you wish to attach the extensions, make sure that the hair is clean and free of styling products.
Step 2. Use a plastic heat-resistant separator disk(hair protector) to protect the scalp from the fusion areas, slip hair through the hole.
Step 3. Clip the disk in place and hold the strands where you will attach the extensions
Step 4. Place the extension below the strands and cup the hair inside the extension.
Step 5. Once you are certain the extension is in place, take your fusion iron and melt the glue fusing it together with the hair strands.
Step 6. Be careful not to wipe away the glue with your fusion iron.
Step 7. Use your fingers to roll the extension and hair strands together to form a strong attachment, try to make the adhesion points as small as possible.
Step 8. When done properly, the extension should rest close to the hairline and be completely sealed, repeat as necessary for desired effect. Don’t wash hair for 24 hours after attaching extensions.
Remove:
Step 1. use acetone-remover and squeeze liquid onto the glued area. Let liquid absorb.
Step 2. use pliers to break the seal and loosen the grip of the extetnsion
Step 3. slide extension out, repeat as necessary slight residue may still appear. Wash hair once all extensions are completely removed.